|Page 1 of 1|
|Author:||haver [ 2007-09-04 04:37:11 ]|
|Post subject:||Table style|
As a teacher, I have to create work sheet with some space to write down the answers. I usually make an empty table after each question where they can write their answers. I erase the line on each side to give the impression that these are lines to write on.
Now here is my question: is it possible to make a table style so that I dont have to do all the table formating manually?
Thank you for your help.
|Author:||GBeurlen [ 2007-09-04 05:02:54 ]|
I am afraid you may not. But you can create a glossary entry: in a NW Pro document, do the table formatting you want, select and copy it. Open the Preference --> QuickFix dialog where you may create a new Glossary. Paste the formatted table into it and assign an expanding key.
Rio de Janeiro RJ Brazil
|Author:||scottwhitlock [ 2007-09-04 06:29:54 ]|
The glossary is so powerful (as this example shows). Too bad it gets almost no mention in the manual.
|Page 1 of 1||All times are UTC - 8 hours|
|Powered by phpBB® Forum Software © phpBB Group