Text Skips a Page and Leaves it Blank

Everything related to our flagship word processor.
Post Reply
Wizardiaoan
Posts: 10
Joined: 2012-07-02 14:44:03

Text Skips a Page and Leaves it Blank

Post by Wizardiaoan » 2017-03-16 17:51:18

Hi,

I do love Nisus but have a problem in one document I can't figure out.

When writing text as it gets to the bottom of the page the text will skip the next page and continue writing on the page after that.
This doesn't occur every time like some "write on every other page" setting, but only now and then throughout the document in a few cases.

To solve the problem I just started a new document and copied everything to it and it worked. I was just wondering what the problem could have been?

Þorvarður
Posts: 251
Joined: 2012-12-19 05:02:52

Re: Text Skips a Page and Leaves it Blank

Post by Þorvarður » 2017-03-18 03:39:46

Hello Wizardiaoan,
Wizardiaoan wrote:I was just wondering what the problem could have been?
Are you sure you haven't accidentally inserted Page/Section Breaks into your document?
Enable "Show Invisibles" and search with the wild card "Any Break."

Any unruly shapes floating around?

If you have pasted text from the Internet or from other programs, it may contain invisible characters that may or may not affect how the text flows. Often these gremlins can be seen if the "Show Invisibles" is enabled. — Here is a macro that removes this invisible junk.
Attachments
Remove Gremlins.nwm.zip
(4.01 KiB) Downloaded 75 times

Wizardiaoan
Posts: 10
Joined: 2012-07-02 14:44:03

Re: Text Skips a Page and Leaves it Blank

Post by Wizardiaoan » 2017-03-19 17:11:40

Thanks sir.

What did you mean by "search with the wild card 'any break'"? How would I do that?

Thanks.

Þorvarður
Posts: 251
Joined: 2012-12-19 05:02:52

Re: Text Skips a Page and Leaves it Blank

Post by Þorvarður » 2017-03-19 18:54:45

Wizardiaoan wrote: What did you mean by "search with the wild card 'any break'"? How would I do that?
Attachments
1.jpg
1.jpg (85.02 KiB) Viewed 1236 times

Post Reply